Xerox XK35C User Guide - Page 25

Installing & Aligning Ink Cartridges Your machine is a dual cartridge inkjet printer. You must use a black ink cartridge and a color ink cartridge. When viewed from the front of the machine, the color ink cartridge is installed in the left cartridge holder and the black ink cartridge is installed in the right cartridge holder. Use the following procedure to install the two ink cartridges and align them. When installing ink cartridges, you must provide specific information to the WorkCentre about the cartridges you install. This allows the printer to monitor ink cartridge utilization. There are two methods of entering cartridge information. n Using the WorkCentre Control Panel buttons n Using the WorkCentre Control Program software and a PC The procedures in this section describe ink cartridge installation without using the WorkCentre Control Program. To install ink cartridges using the WorkCentre Control Program, see Section 5 Maintenance/Control Program. 1 Load sheets of paper (8.5 x 11 inches) into the Automatic Paper Feeder against the right edge of the paper feeder. Squeeze the side paper guide with two fingers to release the guide, and slide the guide all the way to the left side of the paper tray. Ensure that the guide is against the left edge of the paper. For best results, use high quality xerographic copy paper or inkjet paper. 2 Open the entire scanner module (not just the document cover) by lifting the front edge upwards. 3 Support the scanner module by lifting the cartridge compartment lid/support up so the scanner module rests on the top edge of the lid/support. 4 Press the Menu button. A U01 message will appear in the Display. Press Start. The cartridge holder will move left to the open change area. The L-C message (left cartridge) will appear. Ä Getting Started 11