Yamaha CP50 Reference Manual - Page 24

On-screen name (and full name) Description R Resonance This parameter is used to set the resonance of the filter. Reverb Delay This parameter is used to set the interval between early reflections and subsequent full reverberation. Reverb Time This parameter is used to set how long it takes for the reverb sound to fade to silence. Room Size This parameter is used to set the size of the simulated room in which the instrument is being played. Rotor Speed Fast This parameter is used to set the speed of rotation of the low-frequency rotor at the "fast" setting. Rotor Speed Slow This parameter is used to set the speed of rotation of the low-frequency rotor at the "slow" setting. Rotor/Horn Balance This parameter is used to set the relative volumes of the high-frequency horn and the low-frequency rotor. S Sampling Freq. Control This parameter is used to set the sampling frequency. Sensitivity Dynamic Flanger, Dynamic Phaser, and Tech effects: This parameter is used to set how sensitive the modulation is to changes in the input level. VCM Touch Wah: This parameter is used to set how sensitive the wah filter is to changes in the input level. Slow-Fast Time of Horn This parameter is used to set how long it takes for the high-frequency horn to switch between fast and slow rotation speeds. Slow-Fast Time of Rotor This parameter is used to set how long it takes for the low-frequency rotor to switch between fast and slow rotation speeds. Space Type This parameter is used to select the type of space simulation to be applied. Speaker Type This parameter is used to select the type of speaker to be simulated. Speed Control This parameter is used to set the rotation speed as "fast" or "slow". Spread This parameter is used to set how wide the effect's output sounds. Stage This parameter is used to set the number of phase-shifter steps. T Threshold This parameter is used to set the input-signal level at which the effect starts to process the sound. Type This parameter is used to select a reflected-sound type. V Vowel This parameter is used to select a vowel type. W Wall Vary This parameter is used to specify the type of wall in the simulated room (with higher values producing more diffuse reflections). Width This parameter is used to set the width of the simulated room. Word Length This parameter is used to set the resolution of the distorted signal (i.e., how coarse the output sounds). Internal Design of the CP5 & CP50 Reference Left & Right Parts 3
[VOICE] 3
[PRE-AMP] 3
[MOD-FX] 3
[PWR-AMP] (CP5 only) 3
[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3
[COMMON] Song Setting Area 3
[SONG SETTING] 3
[RECORD] TRACK Part 3
[TRACK] MIC INPUT Part 3
[MIC INPUT] (CP5 only) Settings for All Parts 3
[REVERB] Settings for All Performances 3
[MASTER COMPRESSOR] 3
[UTILITY] 3
[FILE] Appendix 24 CP5/CP50 Reference Manual