Yamaha CP50 Reference Manual - Page 42
Settings for All Parts, Reverb Block
UPC - 086792936963
View all Yamaha CP50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Settings for All Parts Reverb Block This section describes the parameters used to configure the reverb effect that is applied to all of the parts from each of your stage piano's Performances. Settings for these parameters are made via the Reverb screen, which contains two pages. Edit Sequence Press and hold the [REVERB] button (for at least one second) Navigate to the required page using the [- PAGE] and [PAGE 3] buttons Turn Knobs 1 to 3 Page On-screen name (and full name) 1 RevType (Reverb Type) 2 RevTime (Reverb Time) HPF (High-pass Filter Cutoff) FBHiDamp (Feedback High Damping) Description This parameter is used to select the type of reverb to be applied. Setting values: RichHall, RichPlt, RichRoom, WoodRoom, Room1, Room2, Stage1, or Stage2 RichHall (Rich Hall) Emulation of hall acoustics with a rich, deep reverb sound. RichPlt (Rich Plate) Emulation of a rich, sustained plate reverb sound. RichRoom (Rich Room) Emulation of room acoustics with a gentle reverb sound. WoodRoom (Woody Room) Emulation of room acoustics with a warm reverb sound. Room1 Emulation of room acoustics with a crisp reverb sound. Room2 Emulation of room acoustics with a deeper reverb sound. Stage1 Emulation of stage acoustics with a wide, sustained reverb sound. Stage2 Emulation of the reverb typical of a smaller stage. This parameter is used to set how long it takes in seconds for the reverb sound to fade to silence. Setting values: WoodRoom 0.3s to 10.0s Other reverb types...........0.3s to 30.0s This parameter is used to set the cutoff frequency for the Reverb block's high-pass filter. Setting values: 20Hz to 8.0kHz This parameter is used to adjust the brightness' of the reverb sound. At higher settings, it takes longer for the high-frequency component to decay, producing a brighter overall reverb sound. This parameter is not displayed on-screen when RevType has been set to "WoodRoom". Setting values: 0.1 to 1.0 Internal Design of the CP5 & CP50 Reference Left & Right Parts 3[VOICE] 3[PRE-AMP] 3[MOD-FX] 3[PWR-AMP] (CP5 only) 3[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3[COMMON] Song Setting Area 3[SONG SETTING] 3[RECORD] TRACK Part 3[TRACK] MIC INPUT Part 3[MIC INPUT] (CP5 only) Settings for All Parts 3[REVERB] Settings for All Performances 3[MASTER COMPRESSOR] 3[UTILITY] 3[FILE] Appendix 42 CP5/CP50 Reference Manual