Yamaha CP50 Reference Manual - Page 41

Page On-screen name (and full name) Description 3 CompTh (Compressor Threshold) This parameter is used to set the input level at which the compressor starts compressing the sound. Setting values: -48dB to -6dB 4 CompRat This parameter is used to set the compression ratio. (Compression Ratio) Setting values: 1.0 to 20.0 CompOut (Compressor Output Level) This parameter is used to adjust the compressor's output level. Setting values: 0 to 127 5 L.Freq (Low Frequency) This parameter is used to set a low-band frequency for boosting or cutting of the sound. Setting values: 32Hz to 2.0kHz L.Gain (Low Gain) This parameter is used to set the degree to which low-band frequencies will be boosted or cut. Setting values: -12dB to +12dB 6 M.Freq (Mid Frequency) This parameter is used to set a mid-band frequency around which the sound will be boosted or cut. Setting values: 100Hz to 10.0kHz M.Gain (Mid Gain) This parameter is used to set the degree to which mid-band frequencies will be boosted or cut. Setting values: -12dB to +12dB M.Width (Mid Width) This parameter is used to set the width of the mid-frequency EQ band. Setting values: 0.1 to 12.0 7 H.Freq (High Frequency) This parameter is used to set a high-band frequency for boosting or cutting of the sound. Setting values: 500Hz to 16.0kHz H.Gain (High Gain) This parameter is used to set the degree to which high-band frequencies will be boosted or cut. Setting values: -12dB to +12dB Mic Insert Effect Screen From the Mic Insert Effect screen, you can select and configure an insertion effect to process audio signals input via the MIC INPUT jack. Depending on the effect selected, this screen can contain up to six pages. Edit Sequence Press and hold the [MIC INPUT] button (for at least one second)  Navigate to Page 2 using the [PAGE 3] button or [2] button  Press Knob 2  Navigate to the required page using the [- PAGE] and [PAGE 3] buttons  Turn Knobs 1 to 3 Page On-screen name (and full name) 1 MicInsType (Mic Insert Effect Type) 2 to 6 Effect parameters Description This parameter is used to select a category and effect type for the MIC INPUT part's audio signals. These categories and effects are identical to those from the Modulation Effect block's Other group, and more details can be obtained from the table on page 16. The parameters presented on Page 2 onward will depend on the MicInsType settings. For more details, see Parameters for non-piano voice effects (page 19). Internal Design of the CP5 & CP50 Reference Left & Right Parts 3
[VOICE] 3
[PRE-AMP] 3
[MOD-FX] 3
[PWR-AMP] (CP5 only) 3
[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3
[COMMON] Song Setting Area 3
[SONG SETTING] 3
[RECORD] TRACK Part 3
[TRACK] MIC INPUT Part 3
[MIC INPUT] (CP5 only) Settings for All Parts 3
[REVERB] Settings for All Performances 3
[MASTER COMPRESSOR] 3
[UTILITY] 3
[FILE] Appendix 41 CP5/CP50 Reference Manual