Yamaha CP50 Reference Manual - Page 39

TRACK Part Whenever a Preset Drum Pattern or a Wave file has been selected as the Performance's backing track, the corresponding data will be assigned to the TRACK part. The following provides a detailed description of the parameters used to configure this part. Edit Sequence Press and hold the [TRACK] button (for at least one second)  Turn Knobs 1 to 3 On-screen name (and full name) Volume Pan RevSend (Reverb Send) Description This parameter is used to adjust the part's output level. It can also be set at any time using the [TRACK] knob on the control panel. Setting values: 0 to 127 This parameter is used to adjust the part's stereo panning. It is available only when a Preset Drum Pattern has been selected for use as the backing track. Setting values: L63 (far left) to C (center) to R63 (far right) This parameter is used to set how much of the part's output signal is sent to the Reverb block. Higher values produce a more pronounced reverb sound. It is available only when a Preset Drum Pattern has been selected for use as the backing track. Setting values: 0 to 127 Internal Design of the CP5 & CP50 Reference Left & Right Parts 3
[VOICE] 3
[PRE-AMP] 3
[MOD-FX] 3
[PWR-AMP] (CP5 only) 3
[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3
[COMMON] Song Setting Area 3
[SONG SETTING] 3
[RECORD] TRACK Part 3
[TRACK] MIC INPUT Part 3
[MIC INPUT] (CP5 only) Settings for All Parts 3
[REVERB] Settings for All Performances 3
[MASTER COMPRESSOR] 3
[UTILITY] 3
[FILE] Appendix 39 CP5/CP50 Reference Manual