Yamaha CP50 Reference Manual - Page 26

For non-piano voices: *OT5ZQF


& Effect category
183  3E * Effect name In the case of non-piano voices, effects are selected from the categories that make up the Other group as described above. In addition, the power amplifiers and the compressor designed for PIANO and E.PIANO voices are grouped together in the PWR category. See For PIANO and E.PIANO voices (page 25) for more details on these. All effects for non-piano voices function as insertion effects. Configuring Power-Amplifier / Compressor Block Parameters Edit Sequence Press and hold the [PWR-AMP] button (for at least one second)  Navigate to the second and subsequent pages using the [- PAGE] and [PAGE 3] buttons  Turn Knobs 1 to 3 Each power-amplifier / compressor type is configured using a different set of parameters, which adjust the sound produced by the block in various ways. All parameters for the power amplifiers and the compressor specially designed for PIANO and E.PIANO voices are described in alphabetic order in the following table. The effects from the Other group are identical to those from the Modulation Effect block, and details on their parameters can be obtained from the table on page 19. NOTE For more details on the specific parameters associated with each different type of effect, see the Power-Amplifier / Compressor parameter list in the Data List pdf document. Power-Amplifier & Compressor Parameters On-screen name (and full name) A Attack Associated effects Compressor 376 D Drive L LineBal (Line Balance) O Output R Ratio Release Compressor 376 PowerAmp 71Rd I/73Rd I/ 75Rd I/78Rd II/69Wr/77Wr PowerAmp 71Rd I/73Rd I/ 75Rd I/78Rd II/69Wr/77Wr, Compressor 376, and Clean Amp Compressor 376 Compressor 376 Description This parameter is used to set the amount of time that elapses between arrival of an input signal and activation of the compressor. This parameter is used to adjust the degree to which compression is applied. This parameter is used to adjust the balance between the speaker output (S) and line output (L). This parameter is used to set the output level. This parameter is used to set the compression ratio. This parameter is used to set the amount of time over which the compressor stops compressing the sound. Internal Design of the CP5 & CP50 Reference Left & Right Parts 3
[VOICE] 3
[PRE-AMP] 3
[MOD-FX] 3
[PWR-AMP] (CP5 only) 3
[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3
[COMMON] Song Setting Area 3
[SONG SETTING] 3
[RECORD] TRACK Part 3
[TRACK] MIC INPUT Part 3
[MIC INPUT] (CP5 only) Settings for All Parts 3
[REVERB] Settings for All Performances 3
[MASTER COMPRESSOR] 3
[UTILITY] 3
[FILE] Appendix 26 CP5/CP50 Reference Manual