Yamaha CP50 Reference Manual - Page 29
Setting values, fingr, EGAtk AEG Attack Time, EGDcy AEG Decay Time, EGRel AEG Release Time
UPC - 086792936963
View all Yamaha CP50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Page 5 6 7 On-screen name (and full name) Description PortaSw (Portamento Switch) This parameter is used to turn the portamento effect on or off for the current part. Setting values: on or off Time (Portamento Time) This parameter is used to set the amount of time it takes for portamento pitch sweeps with the current part. Setting values: 0 to 127 Mode (Portamento Mode) This parameter is used to specify how the current part's playing style will affect the way in which portamento is applied. Setting values: fingr (Finger mode) or full (Full mode) fingr Portamento is only applied when you play legato (i.e., playing the next note before releasing the previous one). full Portamento is applied to all notes. F.Cutof (Filter Cutoff) The term "cutoff frequency" is used to describe the center frequency at which a filter cuts unwanted frequencies. By setting the cutoff frequency, you can change the way in which the filter affects the sound of the part. This parameter is used to increase or decrease the cutoff frequency relative to that set for the current part. Setting values: -64 to +0 to +63 F.Reso (Filter Resonance) This parameter is used to increase or decrease the filter resonance relative to that set for the current part. Setting values: -64 to +0 to +63 EGAtk (AEG Attack Time) EGDcy (AEG Decay Time) EGRel (AEG Release Time) These parameters are used to adjust the attack, decay, and release times for the part's amplitude envelope generator. The higher the value set, the longer it will take for the amplitude to reach the next level (i.e., the slower the change in volume). Setting values: -16 to +16 EGAtk (AEG Attack Time) Sets the amount of time it takes for the amplitude to reach its maximum level after a key is played. EGDcy (AEG Decay Time) Sets the amount of time it takes for the amplitude to drop to the decay level after reaching its maximum. EGRel (AEG Release Time) Sets the amount of time it takes for the amplitude to drop to zero after the key is released. Amplitude Attack level Decay level 0 Attack time Decay time Release time Time 8 NoteLimit (Note Limits) Key played (Note On) Key released (Note Off) NOTE The EGDcy and EGRel settings can also be adjusted using the Decay and Release parameters (page 13) from the Pre-Amplifier block. These parameters are used to define a keyboard section for the current part. Specifically, Knob 1 is used to set the lowest note in the section; Knob 2 is used to set the highest. Setting values: C-2 to G8 29 CP5/CP50 Reference Manual Internal Design of the CP5 & CP50 Reference Left & Right Parts 3[VOICE] 3[PRE-AMP] 3[MOD-FX] 3[PWR-AMP] (CP5 only) 3[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3[COMMON] Song Setting Area 3[SONG SETTING] 3[RECORD] TRACK Part 3[TRACK] MIC INPUT Part 3[MIC INPUT] (CP5 only) Settings for All Parts 3[REVERB] Settings for All Performances 3[MASTER COMPRESSOR] 3[UTILITY] 3[FILE] Appendix