Yamaha CP50 Reference Manual - Page 34

Setting Controllers (Pages 3 to 5) Edit Sequence Press the [COMMON] button  Navigate to Page 3, 4, or 5 using the [- PAGE] and [PAGE 3] buttons  Turn Knobs 1 to 3 Page Pages 3 to 5 On-screen name (and full name) Source Description This parameter is used to select the controller to be edited. Setting values: CP5 Performances: PB (Pitch Bend wheel), FC1 (Foot Controller 1), FC2 (Foot Controller 2), FS (assignable foot switch) CP50 Performances: PB (Pitch Bend wheel), FC (Foot Controller), FS (assignable foot switch) FC1 or FC2 (CP5) / FC (CP50) Foot controller(s) connected to the FOOT CONTROLLER jack(s) FS Foot switch connected to the ASSIGNABLE jack 3 CP5: These parameters are used to assign the controllers selected using L1Dest (LEFT1 Destination) Source with a function for the corresponding part. L2Dest (LEFT2 Destination) Setting values: As follows. CP50: LDest (LEFT Destination) Source Destination 4 CP5: PB (Pitch Bend) R1Dest (RIGHT1 Destination) off or modFx (modulation effect) R2Dest (RIGHT2 Destination) FC1 or FC2 (CP5 Foot Control- off, volume, or modFx CP50: ler 1 or 2) / FC (CP50 Foot Controller) RDest (RIGHT Destination) FS (assignable foot switch) off, vibrato, modFx, or pwrAmp (CP5 only) NOTE If "modFx" is selected as a destination with Source set to "PB", "FC1", "FC2", or "FC", you can then use the corresponding controller to adjust one of the parameters from the Modulation Effect block up or down with respect to the current setting. For details on the actual parameter that will be assigned, see the Modulation Effect block's parameter list in the Data List pdf document. Specifically, the parameter marked  in the Control field will be assigned to the controller. NOTE If Source is set to "FS", the function assigned as the destination can be turned on and off by pressing the controller in question. If the destination is specified as "vibrato", "modFx", or "pwrAmp", pressing the controller will have the same effect as pressing the [PRE-AMP], [MOD-FX], or [PWR-AMP] button. For details on how this will affect the sound, refer to the Quick Guide section from the Owner's Manual booklet. 5 Mode (Switch Mode) This parameter is available only when Source has been set to "FS". It is used to specify whether the controller in question will operate as a latch-type or momentary-type switch. Latch-type switches remain on or off after being operated, while momentary-type switches remain on only while they are being operated. Setting values: momentary or latch Internal Design of the CP5 & CP50 Reference Left & Right Parts 3
[VOICE] 3
[PRE-AMP] 3
[MOD-FX] 3
[PWR-AMP] (CP5 only) 3
[LEFT1]/[LEFT2]/[RIGHT1]/ [RIGHT2] (CP5) [LEFT]/[RIGHT] (CP50) 3
[COMMON] Song Setting Area 3
[SONG SETTING] 3
[RECORD] TRACK Part 3
[TRACK] MIC INPUT Part 3
[MIC INPUT] (CP5 only) Settings for All Parts 3
[REVERB] Settings for All Performances 3
[MASTER COMPRESSOR] 3
[UTILITY] 3
[FILE] Appendix 34 CP5/CP50 Reference Manual