Yamaha CVP-206 Owner's Manual - Page 157
After completing the assembly, please, check the following., Voltage Selector - reviews
View all Yamaha CVP-206 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
6 Connect the speaker cord. 1 Before connecting the speaker cord, remove the vinyl tie attaching the speaker cord to the front panel. 2 Insert the speaker cord plug into the connector, with the plug's tab facing the rear. 7 Connect the pedal cord. 1 Insert the pedal cord plug into the pedal connector. 2 Attach the cord holders to the side panel as shown, then clip the cord into the holders. 8 Attach the rear panel. 2 Secure the left and right corners using the 4x14mm thin screws. 1 With the rear panel on the feet's protruding edge, align the panel with the groove and secure the top of the panel. 3 Secure the top center and bottom of the panel using the 4x20mm tapping screws. 9 Set the voltage selector and connect the power cord. CVP-206: Keyboard Stand Assembly Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. WARNING • An improper voltage setting can cause serious damage to the Clavinova or result in improper operation. 10 Set the adjuster. Rotate the adjuster until it comes in firm contact with the floor surface. ■ After completing the assembly, please check the following. • Are there any parts left over? → Review the assembly procedure and correct any errors. • Is the Clavinova clear of doors and other movable fixtures? → Move the Clavinova to an appropriate location. • Does the Clavinova make a rattling noise when you shake it? → Tighten all screws. • Does the pedal box rattle or give way when you step on the pedals? → Turn the adjuster so that it is set firmly against the floor. • Are the pedal and power cords inserted securely into the sockets? → Check the connection. • If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws. When moving the instrument after assembly, always hold instrument by the lower surface in the front of the main unit and by the handles in the rear panel. CAUTION Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury. Top portion 240 220 110 127 Key cover CVP-206/204 157