Yamaha DVR-S150 Owners Manual - Page 75
Configuring the Audio Input Signal Setting
View all Yamaha DVR-S150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
CONFIGURING THE AUDIO INPUT SIGNAL SETTING Configuring the Audio Input Signal Setting You can play back most audio sources without a problem with the factory audio input signal setting (AUTO). However, depending on your needs, you can configure the audio input mode to specify an input signal type that can be used on the CinemaStation. Also, you can check the type of the audio signal currently input into the CinemaStation (page 71) with the CinemaStation display. y • You can also switch input modes for the currently selected input STANDBY/ON POWER TV by pressing and holding INPUT on the CinemaStation. • If a Dolby Digital or DTS signal is input while the input mode is AUDIO ANGLE SUBTITLE set to "AUTO", the CinemaStation automatically select the SURROUND SELECT MATRIX 6.1 STEREO REPEAT A-B NIGHT SW CENTER SURR SET MENU TV INPUT SHIFT most suitable decoder for the signal. • With "Input Mode" in the Set Menu (page 79), you can set the mode that the CinemaStation automatically selects when it is turned on. TV CH A B C D E SLEEP Notes PRESET PRESET FREQ/RDS MODE PTY SEEK START • You cannot set "ANLG" for the DVD/CD input selection button. ON SCREEN START YPAO CH ENTER MENU CH STATUS RETURN ON/OFF TV VOL MUTE TEST VOLUME • You cannot switch input mode for the button if no external AV equipment is connected to the corresponding input jacks. • To play back a DTS signal, be sure to set the input mode to "AUTO" or "DTS". Setting the mode to "ANLG" may produce noises or no sounds. • The following conditions may happen if a DTS signal is input while the input mode is set to "AUTO". AMP DVD/CD VCR VIDEO TUNER Input selection buttons - If the CinemaStation detects a DTS signal, it automatically switches to DTS mode (t lights up). Once DTS audio playback finishes, the t blinks for a while. While it is blinking, you cannot play back audio source other than DTS MOVIE MUSIC SPORTS GAME signals. If you want to play normal PCM audio soon after DTS playback, set the input mode to "AUTO" again. CINEMA - If the DTS signal is interrupted when you perform Search or Skip, the t may blink. If this condition continues for over 30 seconds, the Input mode automatically changes from DTS to normal digital (PCM) and the t goes out. 1 Press and hold the Input selection button for the current input source until the input mode you want to select appears in the CinemaStation display. While holding down the button, the input mode changes as follows: ↓ AUTO ↓ DTS ↓ ANLG AUTO: Plays a source according digital signals priority over analog signals. DTS: Plays only DTS signals. ANLG: Plays only analog signals. 70