Yamaha DVR-S150 Owners Manual - Page 87
The Set Menu configurations, The Set Menu
View all Yamaha DVR-S150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Troubleshooting Problem A digital equipment or highfrequency equipment produces noises The Set Menu configurations have been cleared The volume does not increase or sounds are distorted Recording sounds does not reflect the sound field effect settings Sound played on the CinemaStation cannot be recorded with an external recorder Sounds played on the AV equipment connected to the CinemaStation cannot be recorded with external recording equipment The CinemaStation does not operate properly A digital equipment or highfrequency equipment produces noises The Set Menu configurations have been cleared Cause The CinemaStation may be placed close to the digital equipment or high-frequency equipment. The power to the CinemaStation may be lost more than a week. The power of the component connected to a CinemaStation's output jack may be turned off. The sound field effects are not available for recording. You may be trying to make a digital recording with an analog source, or analog recording with a digital source. The recording equipment may be connected to the CinemaStation with an analog connection. Either the AV equipment or recording equipment may be connected to the CinemaStation with a digital connection. The CinemaStation may receive a strong electrical shock, such as from a lightening bolt or excessive static electricity, or drop in power supply. The CinemaStation may be placed close to digital equipment or highfrequency equipment. The power to the CinemaStation may be lost more than a week. Solution Place the CinemaStation further away from such equipment. Make sure the power cable is plugged into the outlet firmly, then configure the Set Menu settings again. (page 75) Turn on the power of the component connected to a CinemaStation's output jack. Use proper audio sources. Connect them with a digital connection. (page 16) Connect those equipment to the CinemaStation with analog connections. (page 16) Set the CinemaStation to the Standby mode, then disconnect the power cable. Wait for about 30 seconds, then connect the power cable and turn on the CinemaStation. Place the CinemaStation further away from such equipment. Make sure the power cable is plugged into the outlet firmly, then configure the Set Menu settings again. (page 75) 82