Yamaha RX-V1600 Owner's Manual - Page 102

REMOTE CONTROL FEATURES Using RE-NAME You can change the name of the input source that appears in the display window on the remote control if you want to use a different name than the factory preset. This is useful when you have set the input selector to control a different component. 1 Set AMP/SOURCE/TV to AMP or SOURCE. AMP SOURCE TV 2 Press an input selector button to select the source component you want to rename. The selected component name appears in the display window. A XM AUDIO SEL SLEEP PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 5 Press l / h to move the cursor to the next position. PRESET/CH A-E/CAT. ENTER 6 Press ENTER to set the new name. OK appears in the display window if renaming was successful. NG appears in the display window if renaming was unsuccessful. In this case, start over from step 4. y If you continuously want to rename another component, press the input selector button or SELECT k / n to select the component, then repeat steps 4 through 6. 7 Press RE-NAME again to exit the renaming mode. RE-NAME (U.S.A. model) 3 Press RE-NAME using a ballpoint pen or similar object. RE-NAME Note ERROR appears in the display window if you press a button not indicated in the respective step, or when you press more than one button simultaneously. Note If you do not complete each of the following steps within 30 seconds, the renaming mode will be automatically canceled. In this case, press RE-NAME again. 4 Press k / n to select and enter a character. Pressing n changes the character as follows: A to Z, 1 to 9, 0, + (plus), - (hyphen), ; (semicolon), / (slash), and space. (Pressing k changes the characters in reverse order.) PRESET/CH A-E/CAT. ENTER 98