Yamaha RX-V1600 Owner's Manual - Page 20
supplied speaker terminal wrench., Tighten the knob to secure the wire using
UPC - 027108924229
View all Yamaha RX-V1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
CONNECTIONS 1 Remove approximately 10 mm (3/8 in) of insulation from each of the speaker cables. 10 mm (3/8 in) 5 Tighten the knob to secure the wire using the supplied speaker terminal wrench. Speaker terminal wrench 2 Twist the exposed wires of the cable together to prevent short circuits. Red: positive (+) Black: negative (-) 3 Loosen the knob using the supplied speaker terminal wrench. Speaker terminal wrench 6 Hook the speaker terminal wrench onto WRENCH HOLDER on the rear panel of this unit when not in use. Red: positive (+) Black: negative (-) 4 Insert one bare wire into the hole on the side of each terminal. Red: positive (+) Black: negative (-) 16
16
CONNECTIONS
1
Remove approximately 10 mm (3/8 in) of
insulation from each of the speaker cables.
2
Twist the exposed wires of the cable together
to prevent short circuits.
3
Loosen the knob using the supplied speaker
terminal wrench.
4
Insert one bare wire into the hole on the side
of each terminal.
5
Tighten the knob to secure the wire using the
supplied speaker terminal wrench.
6
Hook the speaker terminal wrench onto
WRENCH HOLDER on the rear panel of this
unit when not in use.
10 mm (3/8 in)
Red: positive (+)
Black: negative (–)
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
Red: positive (+)
Black: negative (–)
Speaker terminal wrench