Yamaha RX-V1600 Owner's Manual - Page 109

ZONE 2/ZONE 3 ■ Using the internal amplifiers of this unit If you want to use one internal amplifier (surround or surround back) of this unit Connect the Zone 2 or Zone 3 speakers directly to the SURROUND/ZONE 2(3) or PRESENCE/ZONE 2(3) speaker terminals and select either SUR or PRNS for ZONE2 AMP or ZONE3 AMP (see pages 87 and 88). If you want to use two internal amplifiers (both surround and surround back) of this unit Connect the Zone 2 or Zone 3 speakers directly to the SURROUND/ZONE 2(3) and PRESENCE/ZONE 2(3) speaker terminals and select BOTH for ZONE2 AMP or ZONE3 AMP (see pages 87 and 88). Third room R+ SURROUND/ZONE 2(3) - - +L R+ - - +L SINGLE SURROUND BACK R L + - PRESENCE/ ZONE 2(3) Second room This unit IMPORTANT SAFETY NOTICE SURROUND/ZONE 2(3) or PRESENCE/ZONE 2(3) speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or more than one loudspeaker per channel. Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low impedance load resulting in amplifier damage. See this owner's manual for correct usage. Compliance with minimum speaker impedance information for all channels must be maintained at all times. This information is found on the back panel of your Receiver. Selecting Zone 2 or Zone 3 You can select the zone you want to control by using the control buttons on the front panel or on the remote control. Once the zone you want to control is selected, you can control the selected zone as described in "Controlling Zone 2 and Zone 3" on page 106. ■ Front panel operations 1 Press MAIN ZONE ON/OFF, ZONE 2 ON/OFF or ZONE 3 ON/OFF on the front panel to individually turn on this unit, Zone 2 or Zone 3. Press each button repeatedly to turn on the respective zone or set it to the standby mode. ON/OFF ZONE ON/OFF ZONE 2 ZONE 3 y Once MASTER ON/OFF on the front panel is pressed inward to the ON position, you can also press POWER and STANDBY on the remote control to turn on this unit, Zone 2 and Zone 3 simultaneously. 2 Press ZONE CONTROL on the front panel repeatedly to select the zone you want to control. ZONE CONTROL Each time you press ZONE CONTROL, the front panel display changes as shown below, and the indicator for the currently selected zone flashes for approximately 5 seconds. However, no indicator flashes when this unit is selected. ZONE2 ZONE3 No indicator flashes when this unit is selected. ZONE2 Controls the Zone 2 component connected to the ZONE 2 AUDIO L/R jacks on the rear panel of this unit. ZONE3 Controls the Zone 3 component connected to the ZONE 3 AUDIO L/R jacks on the rear panel of this unit. ADVANCED OPERATION 105