Yamaha RX-V1600 Owner's Manual - Page 38

p p p p AUTO SETUP 4 Press k / n repeatedly to select WIRING, DISTANCE, SIZE, EQ or LEVEL. 1 AUTO:MENU . SETUP;;;;;;;AUTO WIRING;;;;;;CHECK DISTANCE;;;;CHECK SIZE;;;;;;;;CHECK EQ;;;;;;;;;;NATURAL LEVEL;;;;;;;CHECK START [ ]/[ ]:Up/Down []:Adjust ■ If you selected AUTO in step 3 The RESULT:EXIT display appears after all items are set. RESULT:EXIT WARNING 0 RESULT . SP : 5/4/0.1 . DIST: 4.50/ 6.10m . LVL :-10.0/ +6.5dB . >SET CANCEL [ ]/[ ]:Up/Down [ENTER]:Enter 5 When WIRING, DISTANCE, SIZE or LEVEL is selected, press l / h to select: CHECK To automatically check and adjust the selected item. SKIP To skip the selected item and perform no adjustments. Note When using THX speakers, set SIZE to SKIP and make sure that SML or SMLx2 is selected in SPEAKER SET (see page 78) and that 80Hz is selected in CROSS OVER (see page 79). When EQ is selected, press l / h to select: NATURAL To average out the frequency response of all speakers with higher frequencies being less emphasized. Recommended if the FLAT setting sounds a little harsh. FLAT To average the frequency response of all speakers. Recommended if all of your speakers are of similar quality. FRONT To adjust the frequency response of each speaker in accordance with the sound of your front speakers. Recommended if your front speakers are of much higher quality than your other speakers. SKIP To skip the selected item and perform no adjustments. 6 Press n to select START and then press ENTER. Loud test tones will be output from each speaker and WAIT appears during the AUTO SETUP procedure. 7 Press k / n to select RESULT and then press ENTER to display the AUTO SETUP results. RESULT:WIRING FRONT L;;;;;;;OK []:Select [ENTER]:Return Results of the speaker connection and wiring RESULT:DISTANCE1 FRONT L;;;;4.5m CENTER;;;;;5.2m FRONT R;;;;4.8m PRNS L;;;;;5.2m PRNS R;;;;;5.3m []:Select [ENTER]:Return Results of the speaker distance from the listening position RESULT:SIZE FRONT L;;;;;;LRG []:Select [ENTER]:Return Results of the frequency response of each speaker RESULT:EQ CENTER 1:100Hz;;;+2.5dB 2:300Hz;;;-0.5dB 3:1.5kHz;;+0.5dB 4:1.8kHz;;+2.5dB 5:1.8kHz;;-3.5dB 6:2.5kHz;;+2.5dB 7:10kHz;;;+2.5dB []:Select [ENTER]:Return Results of the parametric equalizer of each speaker RESULT:LEVEL1 FRONT L;;;+1.0dB CENTER;;;;-1.5dB FRONT R;;;+6.5dB PRNS L;;;-10.0dB PRNS R;;;;+1.0dB []:Select [ENTER]:Return Results of the volume level of each speaker y • Press l / h repeatedly to move between each display. • If you are not satisfied with the result or want to manually adjust each setup parameter, run MANUAL SETUP (see page 75). Note If E-10:INTERNAL ERROR appears during testing, restart the procedure from step 3. 34