Yamaha RX-V1600 Owner's Manual - Page 120
After AUTO SETUP - hdcp problems
UPC - 027108924229
View all Yamaha RX-V1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
TROUBLESHOOTING After AUTO SETUP Warning message Cause Remedy W-1:OUT OF PHASE W-2:OVER 24m (80ft) W-3:LEVEL ERROR Speaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly. Check the speaker connections for proper polarity (+ or -). The distance between the speaker and the listening position is over 24 m (80 ft). Bring the speaker closer to the listening position. The difference of volume level among speakers is excessive. (No level correction is made.) Readjust the speaker installation so that all speakers are set in locations with similar conditions. Check the speaker connections. Use speakers of similar quality. Adjust the output volume of the subwoofer. See page 15 - - 15 - 33 Notes • If the ERROR or WARNING screens appears, check the cause of the problem, then perform the AUTO SETUP procedure again. • If warning W-1 appears, corrections are made, but they may not be optimal. • If warning W-2 or W-3 appears, no corrections are made. • If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center. ■ HDMI Error message DEVICE OVER HDCP ERROR Cause Remedy More than 5 HDMI components including Reduce the number of the connected HDMI this unit are connected. components. HDCP testing failed. Check that the connected HDMI components support the HDCP copy protection standards. See page - - 116