ZyXEL MES3500-24F User Guide - Page 153
Link Aggregation Control Protocol
View all ZyXEL MES3500-24F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Chapter 17 Link Aggregation 17.5 Link Aggregation Control Protocol Click in the Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen shown next. See Section 17.2 on page 148 for more information on dynamic link aggregation. Figure 71 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP The following table describes the labels in this screen. Table 42 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP LABEL DESCRIPTION Link Aggregation Control Protocol Note: Do not configure this screen unless you want to enable dynamic link aggregation. Active Select this checkbox to enable Link Aggregation Control Protocol (LACP). System Priority LACP system priority is a number between 1 and 65,535. The switch with the lowest system priority (and lowest port number if system priority is the same) becomes the LACP "server". The LACP "server" controls the operation of LACP setup. Enter a number to set the priority of an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority level. Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports. MES3500-24/24F User's Guide 153