ZyXEL MES3500-24F User Guide - Page 33
Transceiver Installation, 1.3.2, Transceiver Removal
View all ZyXEL MES3500-24F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Chapter 3 Hardware Overview You can change transceivers while the Switch is operating. You can use different transceivers to connect to Ethernet switches with different types of fiber-optic or even copper cable connectors. To avoid possible eye injury, do not look into an operating fiber-optic module's connectors. • Type: SFP connection interface • Connection speed: 1 Gigabit per second (Gbps) or 1 Megabit per second (Mbps) 3.1.3.1 Transceiver Installation Use the following steps to install a mini-GBIC transceiver (SFP module). 1 Insert the transceiver into the slot with the exposed section of PCB board facing down. 2 Press the transceiver firmly until it clicks into place. 3 The Switch automatically detects the installed transceiver. Check the LEDs to verify that it is functioning properly. 4 Close the transceiver's latch (latch styles vary). 5 Connect the fiber optic cables to the transceiver. Figure 11 Transceiver Installation Example Figure 12 Connecting the Fiber Optic Cables 3.1.3.2 Transceiver Removal Use the following steps to remove a mini-GBIC transceiver (SFP module). 1 Remove the fiber optic cables from the transceiver. 2 Open the transceiver's latch (latch styles vary). MES3500-24/24F User's Guide 33