1994 Chevrolet Astro Owner's Manual - Page 236
1994 Chevrolet Astro Manual
Page 236 highlights
10. Remove the two screws at the engine cover using a long handled screwdriver. The screws are not supposed to come out of the cover, only from the front of dash. When removing the cover, careful not to damage the instrument panelor be the trim. 11. Grasp the bottom of the cover and slide it backwards. Then, lift it up and out of the vehicle. To Install the Engine Cover: 1. Lift the engine cover intothe vehicle and slide it all the way forward. Make sure the rubber seal is over the latches. 2. Install the two screws at the engine cover. not tighten the screws all Do the way. 3. Press down on each of the two latches atthe bottom of the cover. Make sure they are secure. 4. Tighten the two screws at the engine cover. 5. Turn the bracket into position and install the bolt. Tighten the nut at the other endof the bracket. 6. Put the heater duct over the engine cover studs. Push on the duct up gently until it snaps into place. 7. Reconnect the electrical connector for the cigarette lighter. 6 - 18