1994 Chevrolet S10 Pickup Owner's Manual - Page 135

8, Press BAND and 000 will appear again.Now you are ready to enter the last three digitsof your code. 9. Repeat steps 6 and for the last three digits of your code. 7 10. Press BAND and rEP will appear for 5 seconds and then000 will appear. 11. Repeat steps 6 through10. This time SEC will appear-indicating that the radio is secure. To Unlock The System After Fower Loss A When battery poweris reapplied to a secured radio, the radio won't turn on and LOC will appearon the display. Enter your secret code as follows: pause no more than 15 seconds between steps. 1. Turn the ignition on. (Radio off .) 2. Depress the SET button. The display will show 009. 3. Enter the six digits of the codefollowing steps 6-9 above. The display will show the numbers as entered. 4. Depress theBAND knob and thetime appears - indicating thatthe disabling sequence was successful. the display indicatesSEC, the If numbers did not match and the unit still secured. is Disabling The Theft System 1. Depress presets 1 and 4 f?r 5 seconds with ignition on and radio power off. The display will show SEC, indicating the unit in the secure is mode. 2. Depress the SET button. The display will show000. 3. Enter thefirst three digits of the code following steps and 7 of the 6 preceding paragraphs.The display will show the numbers entered. as 4. Depress the BAND knob. The radio will display 000. 5. Enter the second three digitsof the code. The display will L-- JW the numbers as entered. 6. Depress theBAND knob. If the display shows the disabling sequence was successful. numbers matched the user-selected code The or the factory back-up code, and the unit in the UNSECURED mode. is If the display shows SEC, the disabling sequence was unsuccessful and the numbers did not match either of the codes andthe unit will remain in the SECURED mode. 3-21