1994 Chevrolet S10 Pickup Owner's Manual - Page 279

Using Foam-Type Cleaner on Fabric Vacuum and brush the area to remove any loose dirt. Always clean a whole trim panel section. Mask surrounding or trim along stitchor welt lines. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. 0 Use suds only and apply with a clean sponge. Don't saturate the material. Don't rub it roughly. As soon as you've cleaned the section, use a sponge to remove the suds. 0 0 Rinse the section with a clean,wet sponge. Wipe off what's left with a slightly damp paper towel cloth. or Then dry it immediately with a blow dryer or a heat lamp. NOTICE: Be careful with a hair dryer or heat You could scorch the lamp. fabric. Wipe with a cleancloth. Using Solvent-Type Cleaner on Fabric First, see if you have touse solvent-type cleaner at all. Some spots and stains will clean better withjust water and mild soap. off If you need to use a solvent: 0 Gently scrape excess soil from the trim material with a clean, dull knife or scraper. Use very little cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning should start the outsideof the at stain, "feathering" toward the center. Keep changing to a clean section of the cloth. When you clean a stainfrom fabric, immediately dry the area with an air hose, hair dryer, or lamp to help prevent a cleaning ring. (See heat the previous NOTICE.)