2003 Chevrolet Tahoe Owner's Manual - Page 151

Each time button 1 or 2 is pressed and released while the vehicle is in PARK (P), a single chime will sound and the memory position will be recalled. If you use the unlock button on the remote keyless entry transmitter to enter your vehicle, the preset driver's seat, throttle and brake pedal, mirror positions and the radio station presets will be recalled if programmed to do so through the Driver Information Center (DIC). The numbers on the back of the transmitters, 1 or 2, correspond to the numbers on the memory controls. The seat, throttle and brake pedals and mirror positions can also be recalled when placing the key in the ignition if programmed to do so through the Driver Information Center (DIC). Easy Exit Seat The controls for this memory function are located on the driver's door. h This button is used to program and recall the desired driver's seat position when exiting/entering the vehicle. The seat position, can be personalized for both driver 1 and driver 2. To store the seat exit position for driver 1 or 2, do the following: 1. Select the desired driver number by pressing and releasing the 1 or 2 button. The seat will move to the stored memory position. To stop recall movement of the memory seat feature at any time, press one of the memory buttons or power seat controls. 2. Adjust the seat to the desired exit position. 3. Press and hold the exit button of the memory control for three seconds. A double chime will sound to let you know that the position has been stored for the identified driver (1 or 2). To use the seat exit position, do one of the following: Press the exit button on the memory control. Or, if this feature is enabled (active) in the DIC, then removing the key from the ignition will cause the seat to move to the exit position. 2-62