2003 Chevrolet Tahoe Owner's Manual - Page 393
2003 Chevrolet Tahoe Manual
Page 393 highlights
Adding Washer Fluid 7 with the Open the cap washer symbol on it. Add washer fluid until the tank is full. Brake Fluid Your brake master cylinder reservoir is filled with DOT-3 brake fluid. See Engine Compartment Overview on page 5-14 for the location of the reservoir. There are only two reasons why the brake fluid level in the reservoir might go down. The first is that the brake fluid goes down to an acceptable level during normal brake lining wear. When new linings are put in, the fluid level goes back up. The other reason is that fluid is leaking out of the brake system. If it is, you should have your brake system fixed, since a leak means that sooner or later your brakes won't work well, or won't work at all. Notice: When using concentrated washer fluid, follow the manufacturer's instructions for adding water. Don't mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage your washer fluid tank and other parts of the washer system.Also, water doesn't clean as well as washer fluid. Fill your washer fluid tank only three-quarters full when it's very cold. This allows for expansion if freezing occurs, which could damage the tank ifit is completely full. So, it isn't a good idea to "top off your brake fluid. Adding brake fluid won't correct a leak. If you add fluid when your linings are worn, then you'll have too much fluid when you get new brake linings. You should add (or remove) brake fluid, as necessary, only when work is done on the brake hydraulic system. in Don't use engine coolant (antifreeze) your windshield washer. It can damage your washer system and paint. 5-40