2003 Chevrolet Tahoe Owner's Manual - Page 439

To store the tools, follow these procedures: For TahoeNukon models do the following: 1. Put the tool kit, with the jack tools and gloves, in the tool bag and place in the retaining clip above the jack. 2. Tighten down with the wing nut. 4. Use the retaining clip to fasten the tool kit on the stud in the storage compartment in the rear left trim panel and turn the wing nut clockwise to secure. 5. Return the storage tray. 3. Then, assemble wheel chocks and bottle jack together with the wing nut and retaining hook. 4. Position behind the jack storage cover in the rear access panel, and tighten, adjusting clockwise until the jack is secured tight in the mounting bracket. Be sure to position the holes in the base of the jack onto the pin in the mounting bracket. For Suburban/Yukon XL models do the following: 1. Return the tool kit (jack tools and gloves) to the tool bag. 2. Assemble wheel chocks and bottle jack together with the wing nut and retaining hook. 3. Position under the jack storage tray in the left rear side panel below the wheelbase and tighten, adjusting clockwise until the jack is secured tight in the mounting bracket. Be sure to position the holes in the base of the jack onto the pin in the mounting bracket. TahoeNukon Models (Rear Access Panel) A. Tool Kit with Jack Tools d. Bracket andWingNut C. WheelWing Block Nut D. Tire Blocks E. Jack 5-86