2010 Jeep Patriot Owner's Manual - Page 281
2010 Jeep Patriot Manual
Page 281 highlights
280 UNDERSTANDING YOUR INSTRUMENT PANEL defrost/floor mode. Attempting to use the recircula- Operating Tips tion while in these modes will cause the LED in the NOTE: Refer to the chart at the end of this section for control button to blink and then turn off. suggested control settings for various weather condi• Most of the time, when in Automatic Operation, you tions. can temporarily put the system into Recirculation Summer Operation Mode by pressing the Recirculation button. However, The engine cooling system in air-conditioned vehicles under certain conditions, while in Automatic Mode, must be protected with a high-quality antifreeze coolant the system is blowing air out the defrost vents. When to provide proper corrosion protection and to protect these conditions are present, and the Recirculation against engine overheating. A solution of 50% ethylene button is pressed, the indicator will flash and then turn glycol antifreeze coolant and 50% water is recommended. off. This tells you that you are unable to go into Refer to "Maintenance Procedures" in "Maintaining Your Recirculation Mode at this time. If you would like the Vehicle" for proper coolant selection. system to go into Recirculation Mode, you must first move the Mode knob to Panel, Panel/Floor and then Winter Operation press the Recirculation button. This feature reduces the Use of the air Recirculation Mode during winter months is not recommended because it may cause window possibility of window fogging. fogging.