2010 Jeep Patriot Owner's Manual - Page 385
2010 Jeep Patriot Manual
Page 385 highlights
384 WHAT TO DO IN EMERGENCIES HAZARD WARNING FLASHER IF YOUR ENGINE OVERHEATS The Hazard Warning flasher switch is located on the In any of the following situations, you can reduce the instrument panel, below the radio. potential for overheating by taking the appropriate action. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional • On the highways - slow down. turn signals will flash on and off to warn oncoming • In city traffic - while stopped, place the transmission traffic of an emergency. Press the switch a second time to in NEUTRAL, but do not increase engine idle speed. turn off the Hazard Warning flasher. NOTE: There are steps that you can take to slow down Do not use this emergency warning system when the an impending overheat condition: vehicle is in motion. Use it when your vehicle is disabled • If your air conditioner (A/C) is on, turn it off. The A/C and is creating a safety hazard for other motorists. system adds heat to the engine cooling system and If it is necessary to leave the vehicle to go for service, the turning the A/C off can help remove this heat. Hazard Warning flasher will continue to operate with the • You can also turn the temperature control to maximum ignition key removed and the vehicle locked. heat, the mode control to floor and the blower control NOTE: With extended use, the Hazard Warning flasher to high. This allows the heater core to act as a may wear down your battery. supplement to the radiator and aids in removing heat from the engine cooling system.