2011 Mercedes CLS-Class Owner's Manual - Page 120

219_AKB; 4; 54, en-US d2ureepe, 2009-05-11T16:21:02+02:00 - Seite 118 Version: 2.11.8.1 118 X Control system Press button V or U repeatedly until the Vehicle status message memory menu appears in the multifunction display. If conditions have occurred causing status messages to be recorded, the number of messages appears in the multifunction display. The following settings and submenus are available in the Settings menu: RResetting to factory settings (Y page 118) RSubmenus in the Settings menu (Y page 119) cluster submenu (Y page 119) submenu (Y page 121) submenu (Y page 124) submenu (Y page 123) Controls in detail RInstrument RLighting RVehicle RConvenience X Press button & or *. The stored messages will now be displayed in the order in which they have occurred. For malfunction and warning messages, see "Vehicle status messages in the multifunction display" (Y page 228). Should the vehicle's system record any conditions while driving, the number of messages will reappear in the multifunction display when the SmartKey in the starter switch is turned to position 0 or removed from the starter switch. With KEYLESS-GO, the number of messages will reappear when you turn off the engine by pressing the KEYLESS-GO start/stop button and open the driver's door. Except for high-priority messages, the vehicle status message memory will be cleared when you switch off the ignition. Resetting to factory settings You can reset the settings of all submenus to the factory settings. For safety reasons, the function Headlamp Mode in the Lighting submenu cannot be reset while driving. X Press button V or U repeatedly until the Settings menu appears in the multifunction display. X Settings menu Introduction In the Settings menu there are two functions: The function To reset, press reset button for 3 seconds., with which you can reset all the settings to the original factory settings and a collection of submenus with which you can make individual settings for your vehicle. X Press the reset button in the instrument cluster (Y page 108) for approximately 3 seconds. The request to press the reset button once more to confirm appears in the multifunction display. Press the reset button once more. The settings you have changed will not be reset unless you confirm the action by pressing the reset button a second time. After approximately 5 seconds, the Settings menu reappears in the multifunction display.