2011 Mercedes CLS-Class Owner's Manual - Page 174

219_AKB; 4; 54, en-US d2ureepe, 2009-05-11T16:21:02+02:00 - Seite 172 Version: 2.11.8.1 172 Useful features Erasing the integrated remote control memory i If you sell your vehicle, erase the codes of all three channels. X X Controls in detail Switch on the ignition. Simultaneously press and hold outer signal transmitter buttons ; and ?, for approximately 20 seconds, until indicator lamp : flashes rapidly. Do not hold for longer than 30 seconds. The codes of all three channels are erased. i Certain types of garage door openers are incompatible with the integrated remote control. If you should experience further difficulties with programming the integrated remote control, contact an authorized Mercedes-Benz Center, or call the Mercedes-Benz Customer Assistance Center (USA only) at 1-800-FOR-MERCedes, or the HomeLink® Hotline (USA only) at 1-800-355-3515, or the Customer Service (Canada only) at 1-800-387-0100. i USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. Any unauthorized modification to this device could void the user's authority to operate the equipment. i Canada only: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. this device must accept any interference received, including interference that may cause undesired operation of the device. Any unauthorized modification to this device could void the user's authority to operate the equipment. Programming tips If you are having difficulty programming the integrated remote control, here are some helpful tips: RCheck the frequency of hand-held remote control A (typically located on the reverse side of the remote). The integrated remote control is compatible with radio-frequency devices operating between 280-390 MHz. a new battery in hand-held remote control A. This will increase the likelihood of the hand-held remote control sending a stronger and more accurate signal to the integrated remote control. performing step 3, hold hand-held remote control A at different lengths and angles from the signal transmitter button (;, = or ?) you are programming. Attempt varying angles at the distance of 2 to 12 inches (5 to 30 cm) away or the same angle at varying distances. another hand-held remote control is available for the same device, try the programming steps again using that other hand-held remote control. Make sure new batteries are in the hand-held remote control before beginning the procedure. the antenna wire from the garage door opener assembly. This may help improve transmitting and/or receiving signals. RPut RWhile RIf RStraighten