2011 Mercedes CLS-Class Owner's Manual - Page 50
2011 Mercedes CLS-Class Manual
Page 50 highlights
219_AKB; 4; 54, en-US d2ureepe, 2009-05-11T16:21:02+02:00 - Seite 48 Version: 2.11.8.1 48 X Occupant safety With a smooth motion, pull the seat belt out of seat belt outlet :. X Place the shoulder portion of the seat belt across the top of your shoulder and the lap portion across your hips. X Push latch plate ; into buckle = until it clicks. X If necessary, adjust the seat belt to the correct height (Y page 48). X If necessary, tighten the lap portion to a snug fit by pulling shoulder portion up. All lap/shoulder belts except the driver's seat belt have special seat belt retractors to secure child restraints properly. For more information on special seat belt retractors, see "Infant and child restraint systems" (Y page 53). To release the seat belt with seat belt release button ?, see (Y page 48). Releasing the seat belts X Safety and security Press seat belt release button ? (Y page 47). Allow the retractor to completely rewind the seat belt by guiding latch plate ; (Y page 47). ! Make sure the seat belt retracts completely. Otherwise the seat belt and/or latch plate could get caught or pinched in the door or in the seat mechanism. This can damage the seat belt and impair its effectiveness, and/or cause damage to the door and/or door trim panel. Such damage is not covered by the Mercedes-Benz Limited Warranty. Damaged seat belts must be replaced. Contact an authorized Mercedes-Benz Center. Enhanced seat belt reminder system When the engine is started, the seat belt telltale 7 will always illuminate for 6 seconds to remind you and your passengers to fasten your seat belts. If the driver's seat belt is not fastened when the engine is started, an additional warning chime will sound. The warning chime goes out after approximately 6 seconds or once the driver's seat belt is fastened. If after these 6 seconds the driver's or the front passenger's seat belt (with the front passenger seat occupied) is not fastened with front doors closed, Rthe Seat belt outlet height adjustment X Raising: Slide the seat belt outlet height adjuster upward. The seat belt outlet height adjuster engages in different positions. X Lowering: Press and hold release button :. X Slide the seat belt outlet height adjuster downward. X Release release button : and make sure the seat belt outlet height adjuster engages into place. seat belt telltale 7 remains illuminated for as long as either the driver's or front passenger's seat belt is not fastened. if the vehicle speed once exceeds 15 mph (25 km/h), the seat belt telltale 7 starts flashing and a warning chime sounds with increasing intensity for a maximum of 60 seconds or until the driver's and front passenger's seat belt are fastened. Rand