2011 Mercedes CLS-Class Owner's Manual - Page 97
2011 Mercedes CLS-Class Manual
Page 97 highlights
219_AKB; 4; 54, en-US d2ureepe, 2009-05-11T16:21:02+02:00 - Seite 95 Version: 2.11.8.1 Power windows and "Convenience closing feature" (Y page 96). If the upward movement of a door window is blocked during the closing procedure, the door window will stop and open slightly. X 95 If the door window is blocked again and opens slightly: X Immediately after the door window was blocked, pull and hold the respective switch upward until the door window is fully closed. The door window closes without automatic reversal function. G Warning! X Switch on the ignition. X Opening/closing: Press or pull and hold switch : to ? to the resistance point. The corresponding door window moves downward or upward until you release the switch. X Pulling and holding the switch to close the door window immediately after it had been blocked two times will cause the door window to close without any reversal function for as long as you hold the switch. Synchronizing door windows The door windows must be synchronized after the battery has been disconnected or if the door windows cannot be fully closed (express operation). Each door window must be synchronized separately. X Close all doors. X Switch on the ignition. X Pull and hold switch :, ;, = or ? (Y page 95) until the respective door window is closed. The door window opens again slightly. X Pull and hold the respective switch once more immediately until the door window is closed completely. X Hold the respective switch for approximately 1 second. The door window is synchronized. Z Express operation: Press or pull switch : to ? past the resistance point and release. The corresponding door window opens or closes completely. X Stopping during express operation: Press or pull the respective switch again. Closing when a door window is blocked G Warning! Make sure that nobody can become trapped and be seriously or even fatally injured when closing a door window with greater force or without automatic reversal function. Controls in detail i After switching off the ignition or removing the SmartKey from the starter switch, you can operate the door windows until you open the driver's or front passenger door. If no door was opened you can operate the door windows for up to 5 minutes. Immediately after the door window has stopped because it was blocked, pull and hold the respective switch upward until the door window is fully closed. The door window closes with greater force.