2011 Mercedes CLS-Class Owner's Manual - Page 128

219_AKB; 4; 54, en-US d2ureepe, 2009-05-11T16:21:02+02:00 - Seite 126 Version: 2.11.8.1 126 Control system your safety and the safety of others, we recommend that you pull over to a safe location and stop before placing or taking a telephone call. If you choose to use the telephone while driving, please use the handsfree device and only use the telephone when weather, road and traffic conditions permit. Some jurisdictions prohibit the driver from using a mobile phone while driving a vehicle. Bear in mind that at a speed of just 30 mph (approximately 50 km/h), your vehicle is covering a distance of 44 feet (approximately 14 m) every second. Controls in detail X Press button 6. You have answered the call. Ending a call or rejecting an incoming call X You can connect your telephone to the COMAND system via Bluetooth®, see separate COMAND system operating instructions. X Switch on the COMAND system. Refer to separate COMAND system operating instructions. X Press button U or V repeatedly until the message TEL appears in the multifunction display. One of the following messages will appear in the multifunction display: RNo Service: No network is available. RBluetooth Press button ~. Dialing a number from the phone book When your telephone is ready to receive calls, you may select and dial a number from the phone book at any time. X Press button U or V repeatedly until the message TEL appears in the multifunction display. X Press button & or * repeatedly until the desired name appears in the multifunction display. If you press and hold button & or * for longer than 1 second, the system scrolls rapidly through the list of names until you release the button again. The stored names are displayed in alphabetical order. Ready: The telephone has not been connected to the COMAND system via Bluetooth® yet. X Connect the telephone to the COMAND system via Bluetooth®. or name of the network provider (if available): The telephone has found a network and is ready for use. You can operate it using the control system. RReady Answering a call When your telephone is ready to receive calls, you can answer a call at any time. In the multifunction display you will then see the following message, or if available, the caller ID (number or name): X Press button 6. The control system dials the selected phone number. If the connection is successful and this feature is supported by your network provider, the name of the party (if stored in