Bosch VIPX1 Operation Manual - Page 20
Connections, Cameras, Audio connections (audio version only), Video In, Line In, Line Out - vip x 16
View all Bosch VIPX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
EN | 20 Connections Installation and Operating Manual | VIP X1 Cameras You can connect one video source to the VIP X1. Any cameras and other video sources that produce a standard PAL or NTSC signal are suitable. - Connect the camera or another video source with a video cable (75 Ohm, BNC connector) to the BNC Video In sockets. - If the video signal is not looped through, termination is performed by a software setting if necessary (see Video input, page 46). Audio connections (audio version only) The audio version of the VIP X1 has two audio ports for audio line signals as well as a microphone input and a loudspeaker output. The audio signals are transmitted two-way and in sync with the video signals. As a result, you can connect a speaker or door intercom system at the destination point, for example. Note If possible you should use the line ports of the intercom for transmitting audio signals on the intercom systems. The following specifications should be complied with in all cases. Line In: Line Out: MIC (microphone): Impedance 9 kOhm typ., 5.5 Vp-p max. input voltage Impedance 16 Ohm min., 3 Vp-p max. output voltage Impedance 2 kOhm typ., 2.8 Vp-p max. input voltage, -20 dB in, supply 2.3 V typ. SPK (speaker): Impedance 4 Ohm min., 6 Vp-p max. output voltage, power output RMS 1 W Installation Bosch Security Systems | 2006-12 | V2.5