Bosch VIPX1 Operation Manual - Page 21
Data interface, The interface is made up of four terminals of the ST500 jack for pin assignment
View all Bosch VIPX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
VIP X1 | Installation and Operating Manual EN | 21 The stereo jack plugs must be connected as follows: Contact Tip Middle ring Lower ring Function Channel 1 (camera) Not used Ground - Connect an audio source with line level to the Line In jack socket of the VIP X1 with a 3.5 mm stereo jack plug. - Connect a unit with line-in connection to the Line Out jack socket of the VIP X1 with a 3.5 mm stereo jack plug. If you wish to connect a microphone and a loudspeaker directly: - Connect the microphone cords to the MIC and GND connections on the pushin terminal. - Connect the loudspeaker cords to the SPK connections on the push-in terminal. Data interface The bidirectional data interface is used to control units connected to the VIP X1, such as a dome camera with a motorized lens. The interface supports the RS232, RS422 and RS485 transmission standards. The interface is made up of four terminals of the ST500 jack (for pin assignment, see page 127). The range of controllable equipment is expanding constantly. The manufacturers of the relevant equipment provide specific information on installation and control. Caution Please take note of the appropriate documentation when installing and operating the unit to be controlled. The documentation contains important safety instructions and information about permitted uses. Note A video connection is necessary to transmit transparent data. Bosch Security Systems | 2006-12 | V2.5 Installation