Brother International BE-1204B Stand Alone Type Instruction Manual - English - Page 102

Chapter 5 Setting Setting of Mending Details of mending can be set in case of a thread breakage. ! Contents of each setting item are as described below. Item Contents For setting a mending end point (number of stitches before a thread breakage) within the range of 1 ~ 10. This function is previously set to 1 stitches upon shipments. For setting whether to reset a thread breakage error automatically. This function is previously set to (Manual) upon shipments. For resetting an error automatically For resetting an error manually For setting whether to stop embroidering temporarily at the mending end point For stopping embroidering at the mending end point For stopping embroidering temporarily at the mending end point and then starting all heads automatically For not stopping embroidering at the mending end point and continuing embroidering Manually trim the lower thread immediately after resetting a thread breakage error if feeding by stitch back is long (i.e., 40 to 50 mm or more) in this mode. Set the thread trimming method to . For setting a thread trimming method using the immediately after resetting a thread breakage error. (This setting is effective only once after resetting the error.) For trimming both upper and lower threads For trimming the lower thread only For not trimming any thread ! Refer to "Mending" (→ Page 6-5). 1. Press . 2. Select by pressing . 3. Press . W0609Q W0612Q 5-12 BE-1204B-BC • BE-1206B-BC