Brother International S-7200B Instruction Manual - English - Page 63

13-11. Adjusting the treadle 13. STANDARD ADJUSTMENTS 2301M If the machine starts running at low speed when your foot is simply resting on the treadle, or if the treadle pressure is felt to be too weak, adjust the position (a to c) at which the treadle spring (1) is hooked onto the treadle lever (2). * a is the weakest position, and it becomes gradually stronger at b and c respectively. 1. Loosen the nut (3) and turn the bolt (4). * When the bolt (4) is tightened, the treadle operation becomes heavier, and when it is loosened, the operation becomes lighter. 2. Tighten the nut (3). Remove the nut (5), and then move the connecting rod joint (6) from the position in figure A to the position in figure B. The treadle stroke will then be increased by approximately 27 %. At this time, the treadle forward and backward depression sensitivity will change, so readjust if necessary. 2302M 13-12. Adjusting the presser foot floating amount (minute lifting amount) 2307M Floating amount When sewing stretch materials and materials with long pile, you can make minute adjustments to the floating amount for the presser foot (1) in accordance with the material. 1. Turn the sewing machine pulley by hand to move the feed dog (2) below the needle plate (3). 2. Use the lifting lever to lower the presser foot (1). 3. Loosen the nut (4). 4. Use a hexagon wrench to turn the adjusting screw (5) to adjust the floating amount. ・ To raise the presser foot (1) ... Turn the adjusting screw (5) clockwise. ・ To lower the presser foot (1) ... Turn the adjusting screw (5) counterclockwise. 5. Tighten the nut (4). * After making the adjustment, sew a piece of material to check the floating amount. Raise Lower 3701M S-7200B 56