Canon GL1 GL1 Instruction Manual - Page 68

Returning to a Pre-Marked Position E OFF CAMERA VCR POWER REC PAUSE SEARCH SELECT ZERO SET MEMORY REW PLAY FF AUDIO DUB. - / STOP + / A/V INSERT PAUSE SLOW ×2 Use the wireless controller to go back to a pre-determined point on a tape following playback. 1. Press the ZERO SET MEMORY button on the wireless controller at a point you want to return to later. • The time code is replaced by a tape counter that is set to zero with the  indication. • Press the ZERO SET MEMORY button once more to cancel the zero set memory. 2. When you have finished playback, fast forward or rewind the tape. The tape stops automatically when it reaches the zero set position. • RTN1 or `RTN appears in the display. • The tape counter with  indication disappears from the display and the time code reappears. Notes: • The zero set memory may not function correctly where there is a break between recordings on the tape. • You can also use zero set memory to mark a position on a tape in record pause mode. When you then play back the tape, pressing rewind will take you back to the pre-marked position. • There may be a slight difference between the timecode and the tape counter readings. • If you remove the tape while the zero set memory is set, the memory is canceled and the tape counter reverts to timecode. • The camera remembers your setting even if you slide the POWER switch to OFF. Using the Full Range of Features 68