Canon GL1 GL1 Instruction Manual - Page 91

Condensation E Condensation may form on the camera when it is moved from a cold place to a warm place. Using the camera while condensation is present can damage both the tape and the camera. Condensation may become a problem: When you take the camera from a cold place to a warm room When a cold room is heated rapidly When the camera is left in a humid room When the camera is taken from an air-conditioned room to a warm, humid place Protecting the camera from condensation • Before you bring the camera to a warm or humid place where condensation is likely to be a problem, unload the cassette and put the camera in a plastic bag. Wait until the camera reaches room temperature before you take it out of the bag. What happens when condensation is detected • "CONDENSATION HAS BEEN DETECTED" is displayed for approximately four seconds. Then, the power indicator flashes and the h mark flashes in the display. If there is a cassette in the camera, it stops automatically and "REMOVE THE CASSETTE" is displayed for approximately four seconds and then v flashes in the display. If you have the beep turned on, it will sound five times. • The camera may not detect the condensation immediately - the condensation warning may not start flashing for 10 to 15 minutes. • You cannot load a cassette when condensation is detected. What you should do • Remove the cassette, leave the cassette compartment open, and turn the camera off. • Leave it in a dry place until the condensation evaporates. After the condensation warning stops flashing, wait at least another hour before trying to use the camera. Additional Information 91