Canon MF7280 imageCLASS MF7280 Sending Guide - Page 325

Multiple Communication Result Report This report is used to check whether documents were sent successfully to the intended destinations when a sequential broadcast transmission was performed. You can set whether to automatically print a Multiple Communication Result Report after sending documents. (See "TX Report," on p. 10-3.) 12/09 2005 10:50 FAX 123XXXXXX CANON TX/RX NO PGS. DEPT. ID TX/RX INCOMPLETE TRANSACTION OK ERROR INFORMATION *** MULTI TX/RX REPORT *** 0010 1 0000001 ------ [ 001]034XXXXXX [ 002]T08XXXXXX 0001 NOTE You cannot print a Multi TX/RX Report with an image of the sent original attached to it even if Report With TX Image is set to On in the TX Report setting. (See "TX Report," on p. 10-3.) ■ TX/RX NO The four digit number, that is automatically assigned when the document is accepted for sending, is printed. ■ DEPT. ID If Department ID Management is set, the Department ID is printed. Appendix ■ PGS. The number of pages that were sent successfully to the destinations is printed. 12 ■ TX/RX INCOMPLETE If a transmission is incomplete, the address and name of the destination are printed. If there is no applicable destination is printed. ■ TRANSACTION OK The address and name of the destination of a completed transmission are printed. If there is no applicable destination is printed. ■ ERROR INFORMATION If an error in transmission occurs, the address and name of the destination are printed. If there is no error is printed. 12-4 Report and List Samples