Cisco WRP400-G1 Administration Guide - Page 170
STUN Test Enable, STUN does not work with a symmetric NAT router. Enable debug through
UPC - 745883580958
View all Cisco WRP400-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Troubleshooting D STUN (Simple Traversal of UDP through NATs) is a protocol defined by RFC 3489, that allows a client behind a NAT device to find out its public address, the type of NAT it is behind, and the port associated on the Internet connection with a particular local port. This information is used to set up UDP communication between two hosts that are both behind NAT routers. Open source STUN software can be obtained at the following address: http://www.voip-info.org/wiki-Open+Source+VOIP+Software NOTE STUN does not work with a symmetric NAT router. Enable debug through syslog (see FAQ#10), and set STUN Test Enable to yes. The messages indicate whether you have symmetric NAT or not. Cisco Small Business WRP400 Administration Guide 168