Cisco WRP400-G1 Administration Guide - Page 21

Product Overview and Deployment Guidelines Remote Provisioning 1 Reboot URL The Reboot URL lets you reboot the WRP400. The Reboot URL is as follows: http://WRP400_ip_address/admin/reboot NOTE The WRP400 reboots only when it is idle. Configuration Profile Because the WRP400 has two sets of parameters, one set for data and one set for voice, the requirements vary from the provisioning of other Cisco Small Business IP Telephony Devices. You will have two profiles: one for the data (router) parameters and one for the voice parameters. One benefit of having separate profiles for voice parameters and data parameters is that you can deploy the common data parameters to all of your customer sites and deploy the custom voice parameters to each site individually. • Data (router) parameters: Use the XML format only, as described in the Provisioning Guide. Binary files are not supported for the configuration of data (router) parameters. For more information about the data parameters, see Appendix B, "Data Fields." • Voice parameters: Use the binary or XML format. The binary format is generated by a profile compiler tool available from Cisco. Find the correct SPA Profiler Compiler (SPC) for the firmware that you have installed on your WRP400. For more information about the data parameters, see Appendix A, "Advanced Voice Fields." NOTE You can download the SPC at the following URL: tools.cisco.com/ support/ downloads/go/Redirect.x?mdfid=282414113 Cisco Small Business WRP400 Administration Guide 19