Cisco WRP400-G1 Administration Guide - Page 19
Remote Provisioning, Upgrade URL - firmware
UPC - 745883580958
View all Cisco WRP400-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Product Overview and Deployment Guidelines Remote Provisioning 1 Factory reset of voice settings: Use one of the following methods: - Option 1: Log on to the configuration utility, and then click Administration tab > Factory Defaults. Next to Restore Voice Factory Defaults, click Yes. Then click Save Settings to begin the operation. - Option 2: Connect an analog phone to the Phone 1 or Phone 2 port. Press **** to access the Interactive Voice Response menu. After you hear the greeting, press 73738 for factory reset. Listen to the prompts and then press 1 to confirm or * to cancel. After you hear "Option successful," you can hang up the phone. Remote Provisioning Like other Cisco Small Business IP Telephony Devices, the WRP400 provides for secure provisioning and remote upgrade. Provisioning is achieved through configuration profiles transferred to the device via TFTP, HTTP, or HTTPS. To configure Provisioning, go to the Provisioning tab in the Configuration Utility. NOTE For complete details, see the Provisioning Guide at the following URL: www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/provisioning/guide/ Cisco_Small_Business_IP_Telephony_Provisioning_Guide.pdf Upgrade URL Remote firmware upgrade is achieved via TFTP or HTTP (firmware upgrades using HTTPS are not supported). Remote upgrades are initiated by causing the WRP400 to request the upgrade firmware image by providing a URL for the WRP400 to retrieve the firmware. NOTE If the value of the Upgrade Enable parameter in the Provisioning page is No, you cannot upgrade the WRP400 even if the web page indicates otherwise. The syntax of the Upgrade URL is as follows: http://WRP400_ip_address/admin/upgrade?[protocol://][servername[:port]][/firmware-pathname] Cisco Small Business WRP400 Administration Guide 17