Cisco WRP400-G1 Administration Guide - Page 80

Advanced Voice Fields Regional page A Voice tab > Regional page > Ring and Call Waiting Tone Spec section IMPORTANT: Ring and Call Waiting tones don't work the same way on all phones. When setting ring tones, consider the following recommendations: • Begin with the default Ring Waveform, Ring Frequency, and Ring Voltage. • If your ring cadence doesn't sound right, or your phone doesn't ring, change your Ring Waveform, Ring Frequency, and Ring Voltage to the following: - Ring Waveform: Sinusoid - Ring Frequency: 25 - Ring Voltage: 80V Ring Waveform Ring Frequency Ring Voltage CWT Frequency Waveform for the ringing signal. Choices are Sinusoid or Trapezoid. The default is Trapezoid. Frequency of the ringing signal. Valid values are 10-100 (Hz). The default is 20. Ringing voltage. Choices are 60-90 (V). The default is 85. Frequency script of the call waiting tone. All distinctive CWTs are based on this tone. The default is 440@-10. Voice tab > Regional page > Control Timer Values (sec) section Hook Flash Timer Min Hook Flash Timer Max Minimum on-hook time before off-hook qualifies as hookflash. Less than this the on-hook event is ignored. Range: 0.1-0.4 seconds. The default is 0.1. Maximum on-hook time before off-hook qualifies as hookflash. More than this the on-hook event is treated as onhook (no hook-flash event). Range: 0.4-1.6 seconds. The default is 0.9. Cisco Small Business WRP400 Administration Guide 78