Cisco WRP400-G1 Administration Guide - Page 61
Line Status Call 1 and 2 Tone - manual
UPC - 745883580958
View all Cisco WRP400-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Advanced Voice Fields Info page A Current Time SIP Bytes Recv External IP Current date and time of the system; for example, 10/3/ 2003 16:43:00. Total number of bytes of SIP messages received (including retransmissions). External IP address used for NAT mapping. Voice tab > Info page > Line Status section (PSTN) Hook State Hook state of the FXO port. Options are either On or Off. Registration State Indicates if the line has registered with the SIP proxy. Last Registration At Last date and time the line was registered. Next Registration In Number of seconds before the next registration renewal. Message Waiting Indicates whether you have new voice mail waiting. Options are either Yes or No. The value automatically is set to Yes when a message is received. You also can clear or set the flag manually. Setting this value to Yes can activate stutter tone and VMWI signal. This parameter is stored in long term memory and survives after reboot or power cycle. Call Back Active Indicates whether a call back request is in progress. Options are either Yes or No. Last Called Number The last number called from the FXO Line. Last Caller Number Number of the last caller. Mapped SIP Port Port number of the SIP port mapped by NAT. Call 1 and 2 State May take one of the following values: • Idle • Collecting PSTN Pin • Invalid PSTN PIN • PSTN Caller Accepted Call 1 and 2 Tone Call 1 and 2 Encoder • Connected to PSTN Type of tone used by the call. Codec used for encoding. Cisco Small Business WRP400 Administration Guide 59