Cisco WRP400-G1 Administration Guide - Page 82

Advanced Voice Fields Regional page A Ccomputer Delay Ccomputer Duration Delay in seconds after caller hangs up when the WRP400 starts removing the tip-and-ring voltage to the attached equipment of the called party. Range: 0-255 seconds. This feature is generally used for answer supervision on the caller side to signal to the attached equipment when the call has been connected (remote end has answered) or disconnected (remote end has hung up). This feature should be disabled for the called party (in other words, by using the same polarity for connected and idle state) and the Ccomputer feature should be used instead. Without Ccomputer enabled, reorder tone will is played after a configurable delay. If Ccomputer is enabled, dial tone will be played when tip-to-ring voltage is restored Resolution is 1 second. The default is 2. Duration in seconds for which the tip-to-ring voltage is removed after the caller hangs up. After that, tip-to-ring voltage is restored and dial tone applies if the attached equipment is still off-hook. Ccomputer is disabled if this value is set to 0. Range: 0 to 1.000 second. Resolution is 0.001 second. The default is 0 (Ccomputer disabled). Voice tab > Regional page > Vertical Service Activation Codes section Vertical Service Activation Codes are automatically appended to the dial-plan. There is no need to include them in dial-plan, although no harm is done if they are included. Call Return Code This code calls the last caller. Call Redial Code The default is *69. Redials the last number called. . The default is *07. Blind Transfer Code Begins a blind transfer of the current call to the extension specified after the activation code. The default is *98. Cisco Small Business WRP400 Administration Guide 80