Compaq Armada E700 Compaq ArmadaStation EM Maintenance and Service Guide - Page 60

Reverse the removal procedure described above to install the power supply., remove the power supply.

Get Compaq Armada E700 - Notebook PC PDF manuals and user guides View all Compaq Armada E700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

7. If a half-height device is installed in the half-height bay, disconnect the half height bay power supply cable from the half-height device – (Figure 5-30). 8. Partially remove the power supply from the base cover. 9. Route the half-height bay power supply cable through the opening in the backplane —. 10. Remove the power supply from the base cover ˜. NOTE: In the illustration below, the half-height device is shown removed from the expansion base. In reality, it is not necessary to remove the half-height device to remove the power supply. Figure 5-30. Removing the Power Supply Reverse the removal procedure described above to install the power supply. 5-30 Removal and Replacement Procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
5-30
Removal and Replacement Procedures
7. If a half-height device is installed in the half-height bay, disconnect the
half height bay power supply cable from the half-height device
(Figure 5-30).
8. Partially remove the power supply from the base cover.
9. Route the half-height bay power supply cable through the opening in the
backplane
.
10. Remove the power supply from the base cover
.
NOTE:
In the illustration below, the half-height device is shown removed from the
expansion base. In reality, it is not necessary to remove the half-height device to
remove the power supply.
Figure 5-30.
Removing the Power Supply
Reverse the removal procedure described above to install the power supply.