Compaq ProLiant 6400R Compaq Parallel Database Cluster Model PDC/05000 for Ora - Page 204
For a Redundant Fibre Channel Arbitrated Loop, Installing Secure Path Software for Windows
View all Compaq ProLiant 6400R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Troubleshooting 7-17 I If the array controllers have already been set to Multibus_Failover mode, then check the integrity of the components along the unseen Fibre Channel Fabric path. Do the following: G Confirm that the Compaq KGPSA device driver was properly installed. Refer to "Installing Secure Path Software for Windows 2000" in Chapter 5, "Installation and Configuration." G Check the status LEDs on the host adapter for error indications. G Verify that the Fibre Channel cable has been properly installed between the host adapter and its Fibre Channel SAN Switch. G Check the status LEDs on the Fibre Channel SAN Switch ports for error indications. G Verify that the Fibre Channel cables have been properly installed from the Fibre Channel SAN Switch to both ports on the array controller. G Use the CLI to obtain status information about the array controller. Verify that both port 1 and port 2 on each array controller are active. For a Redundant Fibre Channel Arbitrated Loop If the cluster node cannot see all of the storagesets that are configured to the FC-AL paths, do the following: I Verify that the array controllers on the unseen path are set for Multibus_Failover mode. If an array controller has not been set to Multibus_Failover mode, then the cluster nodes will only see the storagesets that are configured to the other array controller in the storage subsystem. I If the array controllers have already been set to Multibus_Failover mode, then check the integrity of the components along the unseen FC-AL path. Do the following: G Confirm that the Compaq KGPSA device driver was properly installed. Refer to "Installing Secure Path Under Windows 2000" in Chapter 5, "Installation and Configuration." G Check the status LEDs on the host adapter for error indications. G Verify that the Fibre Channel cable has been properly installed between the host adapter and its Storage Hub. G Check the status LEDs on the Storage Hub ports for error indications.