D-Link DXS-3600-EM-8XS CLI Guide - Page 184

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows the boot-up configuration information stored in the NVRAM. The field descriptions are self-explanatory. DXS-3600-32S#show bootup-config # DXS-3600-32S TenGigabit Ethernet Switch # Configuration # # Firmware: Build 1.10.023 # Copyright(C) 2012 D-Link Corporation. All rights reserved. # DEVICE configure terminal logging-server enable device end # PRIVMGMT configure terminal # COMMAND LEVEL START # COMMAND LEVEL END 9-3 execute flash: This command is used to execute the configuration of device, stored in the NVRAM, by using the increment method. execute flash: FILENAME Parameters FILENAME Specifies the name of the configuration file, stored in the NVRAM. Default Command Mode Command Default Level Usage Guideline None. Privileged Mode. Level: 15 The command is used to execute the configuration by using the increment method. This means that the new configuration will merge with the current configuration. The existing configuration will not be cleared before applying of the new configuration. To verify the executed result, use the show running-config command. Note: The configuration file name and contents can be specified. Once edited, users send the configuration file to the FLASH of the network device in TFTP. The contents of the configuration file will simulate the input completely. Hence, it is necessary to edit the contents of the configuration file by the sequence that CLI commands are configured. Furthermore, for some interactive commands, it is necessary to write corresponding response information in the batch file, guaranteeing that the commands can be executed normally. 176