D-Link DXS-3600-EM-8XS CLI Guide - Page 573

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide spanning-tree no spanning-tree Parameters Default Command Mode Command Default Level Usage Guideline None. The value is disabled in default. Interface Configuration Mode. Level: 8 The spanning-tree/no spanning-tree command allows the Spanning Tree Protocol to be enabled/disabled on the switch interface. Example This example shows how to enable STP on an interface. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)#spanning-tree Success DXS-3600-32S(config-if)# 57-15 spanning-tree hello-time This command is used to configure the MSTP port hello time. Use the no form of this command to return the setting to default setting. spanning-tree hello-time SECONDS no spanning-tree hello-time Parameters SECONDS Specifies the time interval to send one BPDU at the Designated Port. The default setting is 2 seconds. The range is 1 to 2 seconds. Default Command Mode Command Default Level Usage Guideline The default value is 2. Interface Configuration Mode. Level: 8 The port hello time is only used in MSTP version. This parameter cannot be configured in STP or RSTP version. Example This example shows how to configure the port hello time. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)#spanning-tree hello-time 1 Success DXS-3600-32S(config-if)# 57-16 spanning-tree externalcost This command is used to configure the STP port external cost. Use the no form of this command to return the setting to default setting. spanning-tree externalcost COST 565