D-Link DXS-3600-EM-8XS CLI Guide - Page 593

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide 60-3 logging console This command is used to set the severity of logs that are allowed to be displayed on the console. The no format of the command disable show log on console. logging console LEVEL no logging console Parameters LEVEL Specifies the severity of log messages, 0 to 7. The name of the severity or the numeral can be used. Default Command Mode Command Default Level Usage Guideline Debugging level. Global Configuration Mode. Level: 15 When a log severity is set here, the log messages at or below that severity will be displayed on the console. The following table is description about the level: Severity Emergency Alert Critical Error Warning Notice Information Debug Level 0 1 2 3 4 5 6 7 Description System is unusable. Action must be taken immediately. Critical conditions. Error conditions. Warning conditions. Normal but significant condition. Information messages. Debug-level messages. Example This example shows how to set the severity of the log, that is allowed to be displayed on the console, as 6: DXS-3600-32S#configure terminal DXS-3600-32S(config)#logging console informational DXS-3600-32S(config)# 60-4 logging trap This command is used to set the severity of logs that are allowed to be send to the syslog server. The no format of the command disable send log to syslog server. logging trap LEVEL no logging trap Parameters LEVEL Specifies the severity of log messages, 0 to 7. The name of the severity or the numeral can be used. Default Command Mode Command Default Level Informational level. Global Configuration Mode. Level: 15 585