D-Link DXS-3600-EM-8XS CLI Guide - Page 192

running-config DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Specifies that the specified configuration will be executed immediately by using the increment method. The specified configuration will merge with the current configuration. The existing configuration will not be cleared before applying of the specified configuration. Default Command Mode Command Default Level Usage Guideline None. Privileged Mode. Level: 15 The command can be used for: • Executing the configuration file, stored in the NVRAM, immediately by using the increment method. The specified configuration will merge with the current configuration. • Setting the configuration file, stored in the NVRAM, to be the boot-up configuration file. • Downloading the configuration file from the TFTP server or FTP server and executing the downloaded configuration file immediately by using the increment method. The downloaded configuration will merge with the current configuration. • Downloading the configuration file from the TFTP server or FTP server and saving the downloaded configuration file, then setting it to be the boot-up configuration file. If the startup configuration file exists, the boot-up configuration file will be replaced by the downloaded configuration file or else the downloaded configuration file will be saved as 'config.cfg' and be set to be the boot-up configuration file. To download a configuration file then save it to the NVRAM of the device, use this command in the privileged mode: copy {tftp: [//location/filename] | ftp: [//username:password@location:tcpport/ filename]} [vrf VRFNAME] flash: [FILENAME] To specify a configuration file in the NVRAM and upload it or save it to the NVRAM of the device, use this command in the privileged mode: copy flash: [FILENAME] {flash: [FILENAME] | {tftp: [//location/filename] | ftp: [// username:password@location:tcpport/filename]} [vrf VRFNAME]} Note: The two commands described above are common. These commands can also be used for operating with firmware. Example This example shows how to configure the 'config.cfg' file in the NVRAM to be the boot-up configuration file. DXS-3600-32S#copy flash: config.cfg bootup-config Source filename [config.cfg]? y Destination filename bootup-config? [y/n]: y DXS-3600-32S# Example This example shows how to execute the 'config.cfg' file in the NVRAM immediately by using the increment method. DXS-3600-32S#copy flash: config.cfg running-config Source filename [config.cfg]? y Destination filename running-config? [y/n]: y Executing script file y ...... Executing done DXS-3600-32S# 184